Help me spend my hard earned money
Ok so after doing some looking around on a few performance upgrades im undecided on a few. First is programmer I can get a edge drag comp for 500 or so ad then my gauges I haven't priced out yet but im guessing upwards of400 for four gauges and a pod. So should I go that route or maybe the ejwa cs with hot unlock? I figure for the price of the gauges and programmer I could just get the edge? I don't know?
Next is lift pump? I was looking at the factory replacement raptor or a Fass? I really don't plan on doing much after these small things and a better intake. What's your guys thoughts? Im still a few weeks aways from doing it all but its coming soon. Thanks Adam Sent from my dumb phone! |
I wouldn't get the factory replacement pumps, I'd get atleast a 100gph pump but thats me and as far as chip depends if you want analog or digital gauges. If i didnt have a juice w att i would have done comp drag with analog gauges
|
The gauges don't really matter to me. I face money to spend. Just don't know if I really want to drop a grand on gauges anda chip.
Sent from my dumb phone! |
I just installed my raptor150 and its doing great. Simple install not the best of instructions but simple. I'm going with a comp and found a full set of gauges in a junkyard for $100. But If I hadn't don't it the way I did ejwa would be a good route cuz I wont get a Turbo timer in my setup. But on the other hand the pillar gauges look great compared to electronics imo. Either way is a good way. Its your hard earned money get what you prefer. Xdp has some great deals right now the regular comp is 505 shipped
|
I just can't decide.lol.
Sent from my dumb phone! |
I run and AD 100, been going for 6 years now with no issues. I don't recommend getting a direct replacement worthless IMO. You could also get a raptor and remote mount some filters or use the stock filter. I would highly recommend the Edge J/A either cs or cts either way. With the CTS you don't have many mounting options that I am aware of, so keep that in mind.
|
Ok thanks. Im really liking the edge cs, my neighbor has one in his duramax with his efi live. I think im going to do the ejwa cs I think. Des the airdog 100 have filters?
Sent from my dumb phone! |
Yep the AD 100 has filters. :tu:
|
Sweet.appreciate it guys. Think I found a new dash for 75
Sent from my dumb phone! |
Jump on that if you found a complete dash for $75 :c:
|
Well I just need the top piece.how hard is it to replace just the top? I've read around and only seen whole dash removal and replace but Im not doing it all just top part.
Sent from my dumb phone! |
I have never replaced a dash cap but it does take some time. Not really all that hard just time consuming. While your in there I would replace your heater core and condenser core.
|
Ok. Good advice. Do you have to actually remove the stewing column
Sent from my dumb phone! |
I don't think you have to completely remove it, but just unbolt it and let it drop n hang. But don't hold me to that! :c:
|
Definatley not looking forward to this
Sent from my dumb phone! |
I need to figure out how to swap vin tags to
Sent from my dumb phone! |
Yes just unbolt the steering column and lay it down. Not to sure on the vin plate. Shouldn't be to difficult to remove and replace.
Sent from my DROIDX using Tapatalk 2 |
Ok.good dral
Sent from my dumb phone! |
All times are GMT -5. The time now is 11:00 AM. |
© 2024 MH Sub I, LLC dba Internet Brands