turbo suggestions
 

Ok so everyone on here says for my amount of fuel get a turbo before i stack a smarty so here we go what turbo gimme suggestions i hear aurora is good???ny suggestions helpa

with your setup, a phfat shaft 62 or even a phaft shaft 64 would do wonders. but they are expensive. A s300 with a 62 or 64mm inducer will be good and a tad cheaper. Schieds, Industrial injection and HTT are very good normally. BD super B special turbos are pretty good too.

ATS auroa turbos are hit and miss, Personally, I've never ran one but I've got a few buddies who have ran them, some did good, others were complete junk so its pretty much a coin toss for me. Personally, I dont like ATS products, way over priced for what it is in my opinion.

nice nice ok ill have to check out these turbos im not going to be making so mkuch boost i blow a headgasket though will i cause i dont want that!:tttt:

anything else to suggest ??

Re: turbo suggestions
 

Good set if injectors and a 62mm or 64mm turbo will work great.

Luke

head gasket failure is definately possible... i would highly recommend studs before a turbo upgrade..

save yourself time and money and stud the motor before you go any further and I don't recommend the smarty stack with edge you gain some bottom end but loose on the top end. for $500 or more for a smarty you can get a lot more out of something else. I would get a 62 turbo it will be good and you can always add a 471 or 475 under it for some compounds and make good power.

hmm i think u guys are right i will look into the studs

we are.... lol... been there done that... get the studs bud.....
:rocking:

How many psi of boost can the stock turbo handle and what would be the best turbo to upgrade to

What studs would suite me though the 625?

no the less expensive ones will be just fine I have been running them 3 years now 85 psi with o-rings and they hold fine

Hmm ok where did u purchase from

my local shop but post a price quote in the vendor section there are some good prices in there.

Alright i have never used the vendor section what do i put just price quote for head studs 99 cummins?

The ARP head studs are on back order for another 4-6 weeks. I can get you A-1.. they are about $100 more, require bottom tapping, but will hold a little better than ARP.

For how much altogether?