Low pressure light
 

Did a search and could not find anything on installation, but had one question. I just got my low fuel pressure warning light in and was reading through the instructions but did not see anything on what the two supplied washers, metal with a rubber center, were used for and not being very after market savvy I could not figure it out myself :argh: . I did notice the instructions have it three different ways for different different year models, but did not see anything in those sections about the washers either, any insight on this would be very helpful. This is on a 2000 Cummins just for clarification.

From the sound of it, your kit is replacing an existing banjo bolt with one that has a port to get fuel pressure, sound about right. Well those two washers with O-rings in them go with the banjo bolt (one on each side). I would use the new ones and maybe save the old, just because I'm a pack-rat.

I appreciate the input. I talked with my teacher this morning and he said the same thing.