raptor 150 install question
#1
raptor 150 install question
Okay so my raptor should be here tomorrow from mighty diesel and I had a thought, when I go to install the fuel line from the filter housing ill lose my fuel pressure sensor for my edge jwa. So can I use the fitting for the 2001 vp and put that on the vp or can I keep the stock line from the filter to the injection pump so I can still monitor fuel pressure?
#2
#3
#4
I could have swore that the instructions I downloaded said you switched out the line from the filter to the pump, and from the pictures I couldn't retain the stock line. But sounds it doesn't matter so ill just leave the line from the filter to the pump alone.
---AutoMerged DoublePost---
Nevermind I read over it again and I guess it doesn't talk about swapping that line out. So no worries now thanks for the info
---AutoMerged DoublePost---
Nevermind I read over it again and I guess it doesn't talk about swapping that line out. So no worries now thanks for the info
Last edited by wyodiesel92; 08-10-2010 at 11:22 PM. Reason: Automerged Doublepost
#7
doesn't your filter cap have test plugs on it? 98 and 99 were the same if I remember right. they have a 1/8" port on the cap then you don't have to worry about it. depending on what fittings they send you can always put a fitting with 1/8 port on the side of the vp and attach the raptor line there too.
#8
I don't remember what size it was. It does have test ports but the sender from edge went into the banjo fitting on the supply line on the filter
---AutoMerged DoublePost---
Sorry worded that wrong, not the supply to the filter, the out side of the filter that goes to the vp
---AutoMerged DoublePost---
Sorry worded that wrong, not the supply to the filter, the out side of the filter that goes to the vp
Last edited by wyodiesel92; 08-11-2010 at 11:35 AM. Reason: Automerged Doublepost
Thread
Thread Starter
Forum
Replies
Last Post
scottxmorris
24 Valve 2nd Gen Dodge Cummins 98.5-02
3
10-08-2014 02:14 PM