check engine light??
 

so i unplugged my bosst fooler to plug the edge in and i plugged the edge in but the boost wasnt reading and now my check engine light is on. What the hell happened?

what did you unplug? edge reads boost from map sensor. You need to plug the map sensor back in.

i did plug it back in and still i got nothing but the check engine light

Is the edge harness directly plugged into the MAP sensor? Another fooler in the circuit may cause the problem. If you have just the edge harness and the factory harness plugged in, it may just need a battery disconnect and sit for a bit.

i had the edge plugged in and that made the check engine light come on and it wasnt reading boost so i plugged my fooler back in and still my check engine light is on but the light on the boost fooler is on

I assume the factory harness is plugged in as well? If so, there could be an issue with the Edge itself.

well all i unlugged was the boost fooler then i plugged the edge in and it did this

With my Edge I have the Edge harness plugged into the MAP sensor, and the factory boost harness plugged into the Edge harness. It's all working for me, no boost fooler.

well then there is something wrong. because i have no boost raedings fron the edge when its plugged in

Sounds like your factory plug for your map sensor is not plugged in. mine would not build boost till it was...

what doe sth e factory plug look like? i only unpluged 2 things and i plugged them rite back in with the 2 things on the edge i didnt touch anything else and it runs fine just no boost reading on edge and the check engine light is on

Jake if you have a camera take a pic. If it is throwing a code your sensor could be bad or you have a loose connection in a harness somewhere.

so i could just be buyin a new MAP sensor?

I doubt it, if it works without the Edge hooked up it should be fine. Is the Edge harness plugged into the MAP sensor first?