Airdog 150 install help
 

I've got everything mounted like it should be i think. The problem is I'm not getting any diesel from the tank, so I can't prime it. maybe it's something simple and i don't realize it

not insulting your intelligence, but do you have all the wires connected and plugs plugged in? I would trace each wire and just make sure that its connected to wherever its supposed to be at both ends of the harness.

i can hear the pump run when i turn the key. but there are 3 connectiors i didn't use. i have the positive and negative hooked up and the one to the pump itself. am i missing one?

there should be one that plugs into the ECM too I think...Im tryin to remember when I did mine

when you installed the draw straw did you get it far enough in the tank also ive seen it take the side cover off the unit and make sure no trash got picked up

did you fill the water separator with fuel,per the direction's

i got it figured out. i heated the draw straw to fit more easily over the aluminum fitting and when it cooled it cracked :argh:. so i had to cut it and re-do it, luckily i'm not too far off the bottom of the tank but its all good to go now. :yeah:

:tu:enjoy the fuel pressure

:rocking:

:tu: