AD 150 install
 

Do I have to remove stock lift pump from the fuel tank when installing Air Dog:pca1:

No - but you will need one of the DrawStraw products:

http://www.vulcanperformance.com/category-s/220.htm


...or an upgraded tank module.

though 150 kit came with that:humm:

My 150 kit did come with it.

i got the 165 so it did

Thats a big 10-4, mine came with one as well.:U:

thanks guys

Airdog on the way should be here tomorrow:U:

---AutoMerged DoublePost---

ok every body been reading everything I can find on here about AD install. Would like some iput about HI-Flow module mod. Do it or not?:pca1:

still looking for advice on fuel module mod when in stalling AD

I think just about everyone uses the draw straw method. The high flow fuel module is relatively new, IIRC. But supposed to help with the 1/4 tank issues that many are plagued with.

what about fuel heater

dont need a fuel heater unless you live way way way up north.

ok got airdog installed had 15 psi fuel pressure shut truck off installed stelth plate now have only 4 to 6 psi put old pump cover back on now 6 to 8 psi please HELP

if you want to run with the factory fuel heater, you can do the following, take your factory filter and using a hack saw, cut off the filter element about a 1/4 inch from the seal, make sure the gasket is good and bolt it back in, then run you fuel line that comes from your airdog into the filter assembly and youll be good, we did this to a truck a while back, works great theres a similar write up around here some where.

Sounds like a leak in the system if your pressure dropped that much.

Nope, Thats what I was talkin to ya about yesterday luke. It was a issue with the high flow module. Think we've got it solved now!

sorry it's been so long since last post when not working hunting got problem solved will wright it up and post pics verry soon. It was a problem with high flow module.

---AutoMerged DoublePost---

:jump:

yeah.