just to let everyone know the tunes for the newest adrenaline box 98-02 cummins are up and running on quadzilla's website :U:

Outlaw.. how did you get ahold of the 4k tune?

i dont think i have that

whoops... wrong guy :argh:

lol its ok

I have been running the ADRCOMP3 and it is great!
I do have a question though; Does it have high idle, or is it set through the Pulse?

Thanks!

It is set through the pulse under hardware i do believe

Correct:5::rocking:

Got it. It is shut off; you have to enable it first. Instead of a time for it to come on, it would be great if you can set an outside air temp for it to come on, or an EGT temp for it to come on. Being able to set the 3 cyl idle would be the best though!

Borrow a Smarty from someone:U::ok1:

I used to have one so it is loaded on my ECM. I wonder if the Adrenaline high idle needs to be off for it to work though.

What do you think?

Trying to remember:humm: I don't think it does. Seems to me my high idle would kick in and so would the 3cyl. warm up. Won't be long and I'll be able to tell ya:booo::argh:

The Adren high idle must be turned off for the 3cyl high idle to work.


It would be awsome to do it with the Quad as it rarely gets cold enough down here for it to 3cyl high idle on it own.


Luke

It's not cold enough here either, but i like being prepared lol.

you 100% sure on this. Maybe I was just running on the ecm for my high idle and 3cyl. warm up but I thought I had the Adrenaline set for high idle:humm: I'll have to check this out when it gets a little colder here. I know I'll get to hear the 3 cyl. warm up:argh::argh:

Hey... dont complain about it not getting cold enough man... its already been dipping into the 20's at night up here, and it aint long til thats the high

I hope it gets cold here soon...... :choochoo:

I was just about to start my own " pulse questions page " But i just seen this

The pulse has 10 different settings on it doesn't it ? Does that mean you can only change #10 ? to an agressive tune ? Or do they all change when you download a beta tune ?
I want to be able to drive to the Dyno with some street manners, and then crank it over to TRQ mode without having to bring the laptop, Possible ?

Second question :

All these tunes have the high idle setting, can i turn them back off ? Because i am going to be building the ECM / IAT fooler for my truck, and the pulse will indeed turn them off, cause it adjust TPS %.

Last but not least,

Any one acctualy try to run the " ADR2_TORQ " On the street ? the one they tell yah not to ?

1. yes you can run the torq tune... it just gets kinda surgy when under light throttle above 2000 rpm

2. Download the tune to the adr. then under custom tuning save it as tune 1 or tune 2. You will have 10 levels in each tune, but you can change it from 2-14 levels if you want, but it is all the same tune. All you have to do to switch between the 2 tunes is load the tune under custom tuning.

3. The high idle is enabled and disabled under the hardware section in the main menu.

Hope this helps