X-Monitor... Installed, but ???'s
Alright, so I installed my X-Monitor, I'll grab some pics of it tomorrow, mounted it on top of the steering column, and it looks great (just blocks the view of the WTS light). However, I bought the FP kit for it, and it says it needs a 5V source. So thats the first question, how do I drop from 12V to 5V?
Next, my monitor shows Trans Temp, which is not what I need, I need it to show FP. Will it automatically switch to FP once it reads the right voltage, or do I need to reprogram it somehow? That is all...:c: |
:humm:
|
:humm: X2
|
:humm:X3... Thats why I asked... And BD doesn't seem to be much help.
|
Sounds like an electronics project that's going to involve a trip to Radio Shack.
12v > 5v Resistor value... - Overclock3D Forums |
WTF... Why can't they just give me what I need to begin with. This X-Monitor is dropping big time in my book.
|
Goes double for me. Why the heck a 5V source??
|
should have just gone with a quad and pulse or edge juice... no issues that way... did you sell the other monitor you got?
|
Yeah, BigRig bought the TS monitor.
Big thanks to Red Rattler for noticing the MAP sensor is powered by 5V, so I can tap into that for power. Now I just gotta figure out how to change the display from Trans to FP. I'm not installing the FP kit until I install the AirDog I ordered. |
:c: Did you go with the 150? Haven't got mine yet.... :humm:
|
All times are GMT -5. The time now is 09:06 AM. |
© 2024 MH Sub I, LLC dba Internet Brands