yes they are. im going to go home after this class is over so if you want to come over you can.

 

what time is your class over?

 

it will beover around one. then i have 3 hour till i have to come back into town.

 

ok i have a hair cut apointment a 0ne so when im dont with that i will swing by

 

P-PUMPS SUCK......


that is all.......

 

what do you mean they suck they are easy to work on

 

no VE pumps are easy to work on, 7100's are a pain in the ***, at what point does anyone think its a GREAT idea to put 5 point hex security screws in the pump from the factory then mount fuel lines over top of them......i drilled the head off one then backed it out with vise-grips, then drilled the head off the other one and beat it out with a screwdriver and hammer......couldnt even touch the star wheel in the truck cause of the 5 point hex bolts.....NO ONE SELLS 5 POINT HEX SECURITY BITS........

 

i had the same problem with mine just replace them with regular hex head bolts then it is eisyer to make changes

 

Torx Plus is the type of bit it takes..... here does it look like this?


http://www.wihatools.com/700seri/716_IPR_serie.htm

 

i did, if i would of been in a shop somewhere with air and cut off wheel it would of been done quickly and without pain......BUT, i had this to contend with.....http://www.weather.com/maps/maptype/...m=hp_main_maps

i was soaked, working outside under a car cover......as in fabric car cover.....


yes Ben, no hardware place sells them around here.....