Is there any way to rig up a High Idle Cable/switch now that ya mention it without some kit that cost a friggin arm and a leg:humm:
|
ummmmmmmmm!
|
Originally Posted by stkdram55
(Post 229518)
Is there any way to rig up a High Idle Cable/switch now that ya mention it without some kit that cost a friggin arm and a leg:humm:
Of course a broom handle or snow brush wedged between the seat and go pedal works ok too. But you have a 99 which you can do electronically. Just find someone with a Smarty and load it onto your trukc, When they remove the Smarty, the high idle will be enabled. |
Originally Posted by hughesis21
(Post 229521)
ummmmmmmmm!
|
Originally Posted by Dr. Evil
(Post 229523)
Of course a broom handle or snow brush wedged between the seat and go pedal works ok too.
|
hughesis21. No you can't run your block heater that way.
Even if you did manage to do it with an inverter, you'd have a dead battery long before morning. Trying to run a block heater in that way would be like leaving the headlights on. |
yep broom handle time thanks
---AutoMerged DoublePost--- i guess i could just ask the apt manager to furnish me an oversized garage with a heater in it. right!!!! |
Originally Posted by Benjamin
(Post 229526)
i use a piece of 3/4" sch 40 PVC and put it between the seat and accelerator pedal and adjust the power seat to the desired RPM......
some people dont have power seats...lol |
Originally Posted by Dr. Evil
(Post 229523)
I am working on one right now. I will posts some pics if I get it working ok.
Of course a broom handle or snow brush wedged between the seat and go pedal works ok too. But you have a 99 which you can do electronically. Just find someone with a Smarty and load it onto your trukc, When they remove the Smarty, the high idle will be enabled. |
Once enabled, it will activate automatically (when certain conditions are met):
Once enabled, idle speed will slowly ramp up from 800 rpm to 1200 rpm when all of the following conditions are met: 1. Intake Manifold Temperature less than 0°C (32°F) and, 2. Coolant Temp is less than 60°C (140°F) and, 3. The Transmission is in Neutral or Park and, 4. The Service Brake pedal is not depressed and, 5. Throttle = 0% and, 6. Vehicle Speed = 0 mph Here is the TSB: TSB 18-019-01 You can either get a dealer to enable this for you (most charge for this service) or you can load the smarty program on your truck and then remove it. The high idle will remain. But we are getting off topic - this is the 12V area. |
All times are GMT -5. The time now is 06:03 PM. |
© 2024 MH Sub I, LLC dba Internet Brands