P0243 Fault Help
Hey has anyone had any experience with the P0243 Code? It's a Turbocharger waste gate malfunction A code definition. I've got the stock Turbo no motor mods besides an intake/intake elbow. Dealership has been no help :argh: and i can't find and info online. Just joined looking for help and more info on future mods.
---AutoMerged DoublePost--- Oh and the boost is down to around 22 pounds when it was running 30-35 before the fault. Also running a Smarty S-06 Tuner |
Sounds like the wastegate solenoid is at fault.
|
Is there any way to check that besides replacing the solenoid?
|
Turn the Ignition on, engine not running.
Disconnect the Wastegate Solenoid harness connector. Connect an incandescent test light across the supply and driver pins at the Wastegate Solenoid harness connector. NOTE: The ECM will perform a self check of the circuit after approximately 30 seconds, which should light the incandescent test light. Does the light illuminate brightly after 30 seconds of being connected? Yes >> Replace the Wastegate Solenoid. Perform POWERTRAIN VERIFICATION TEST VER - 1 (DIESEL). (Refer to 8 - ELECTRICAL/ELECTRONIC CONTROL MODULES/ENGINE CONTROL MODULE - DIAGNOSIS AND TESTING) |
Thanks bill. Haven't been on in a few days to get this but i'll give it a whirl. Would you know where i could find the powertrain verification test info?
|
If you know of someone that has a Chrysler Star Scan. :humm:
|
Nobody besides the dealership.:dang:
|
I'm not sure if you got a Cummins shop near ya, but I'm pretty sure they got the solenoid (Holset is a Cummins subsidiary). Cheaper than the dealer no less. :tu:
|
I'll definately look into that.
|
All times are GMT -5. The time now is 03:27 AM. |
© 2024 MH Sub I, LLC dba Internet Brands