Abs 2003 dodge ram cummins
 

Abs light and brake light light up !! hooked up a scantool LF sensor no circut, changed the sensor and cleared the code, dosent work. The light is back , all connectors cleaned!! Changed the speed sensor in the rear axle, cleaned the LF sensor. Tried to switch side with the cables,same code??Sometimes when i clear the code the light is off for a couple of minutes and then its back again when i turn the ignition on. :scare2: Even changed the discs and pads:s: any clue?:s: please

Exact same thing just happened on my '06. Anyone got any smart ideas? I'm at a loss, here, and it's MOOSE SEASON!!! Gonna drive it, anyway, and see what THAT gets me!:scare2:

I drove mine for a year that away before i fixed it. It is probably the hub and will cost about 600.00 to fix if you have someone else do the work. I had a friend of mine do the work and the hub cost 242.00 a piece I had him go ahead and replace both sides. Good Luck!!!

Ok! going to try changing hub
Done the disc, pads, connectors, sensors why not the hub:rocking:
Bought one today with abs sensor
Weekend saved

I would imagine it is just the sensor in that hub. Which I believe you can only get with the hub unfortunately :td: These hubs can be pretty stubborn when it comes to taking them off so good luck :tu:

Hmm changed the hub with sensor no luck still light on
:s:

Did you happen to change the opposite side...sometimes right and left depend on the point of view. You changed the other two, why not change the only one left?

you dont have to buy the whole hub assembly to replace the abs sensor, i replaced my hubs, cuz they needed it after 200k. but the dealership sells the sensor by itself for around $60 and it takes about 10 minutes to replace. or you can buy the whole hub assembly for around $300. you may have nicked the sensor on installation, cuz i did that, bought a new sensor and noticed i damaged the orginal when i put it in, hope this was helpful

Did you have the truck scanned to see what was causing the light to be on? It will tell you the exact problem