Stick shift
 

My 2006 dodge3500 stick shakes alot while driving wondering if anyone else has had this problem ?

Where the shifter necks up to a larger diameter on the shifter is the rubber isolator. It may be worn, or you have something loose.

Like when you hit a bump? Yea it's normal either way

It dnt matter if it's the smoothest road ever just shakes all the time way more than normal

Well does if feel sloppy or loose?

It's not sloppy but it ain't like it was when I bought it new neither

mine shakes all the time too, not real bad but it does

Pull the boot up, take the shifter out and put the flat end in a vice to see if thats your problem. Its very simple to remove. And you don't have to take the knob off to remove. :c:

I'm gona check it when I get off and I'll let y'all kno

Is it rhythmic like something inside the trans is moving it, or does it just wiggle around when you hit a bump?

It does it all the time but havnt had ne probs wit the tranny no noise or lose of power just movement in the stick while driving

Does your truck "shake" at idle? stock clutch? Miles?

It's got 123000 has southbend dd

LOL your just worryin to much I think but you can pull the shifter and do what KXTRAP43 said

i pulld it just need to throw it in a vice every other 6spd ive been in they dont hardly move but then again never had probs wit the tranny even wit my edge turned on level 6 so u might be right

I just strapped my stock shifter in a vice. It takes roughly 20 pounds to move it and quite a bit of force to "mushroom" the rubber out of the bottom. Remember, its only supposed to dampen the stick.

I messd wit it and it dnt take that much force to move it so I think it just might be wore out wat u think?

Hard to tell by sending messages or even pics. Thats not something that usually wears out. Especially at that mileage. If you were closer i would slap my shifter in there. Because I'm sure that thing is not the cheapest thing from dodge.

Could be a frozen frunt u-joint are a bad drive shaft U-Joint. How is the frunt end ? how is the tires wearing ?

Inside tire is wearn pretty bad thought it was the ball joints again but they were ok I just replaced all the steering linkage to the new kind dodge is using