rebuild manual or info for a 2004.5
Hi everyone!
I am going to attempt a rebuild on a 2004.5 Dodge 3500 that had the motor pulled with head off when I got it. #6 cylinder needs to be sleeved and new piston installed. The speedo shows 140,000 miles, original owner says it's right. This will be my first cummins rebuild and I am looking for the best manual for doing this. Any advice is appreciated. :hellox: |
Cummins manual's are generally the best way to go but rather expensive. If it were me i would look at having the block o-ringed while it is out, Cheap insurance for future mods. If you can't find one i do have an electronic manual for an 05 Dodge. Let me know if we can help, because if you do decide to o-ring the block you will need to use a custom HG.
Nick |
I am going to stay stock with this build (or close). I think I just found an electronic manual on line and will down load it.
Thanks! I'm sure I will be seeking a lot of advice ! (after further thought, I'll check with the machinist to see how much the cost will be.) |
Our machinist typically charges 200-250 to oring and surface a block. The gasket is around 180-200 for a Genuine Cummins gasket that is modified to fit the o-ring'd head or block.
|
All times are GMT -5. The time now is 05:42 AM. |
© 2024 MH Sub I, LLC dba Internet Brands