Have a few codes, need help
I have three codes and I have been able to identify two of them but the third is not found anywhere.
P-2504 -- high charging system P-0462 -- Fuel level sending unit colts too low PD412 -- Unknown What would cause these codes, I know what caused the P-2504, jumping the loader at work and I think it charged me instead of vise versa:duh3:. As for the other two, what could have caused them and what are the possible solutions. I am still under warranty and have not done any performance mods yet, so I have a perfect warranty. Thanks 06 DIESEL »»»»»»»»»»»«««««««««««« AutoMerged DoublePost »»»»»»»»»»»«««««««««««« Bump |
Go to Autozone and have them reset the codes. Then see if they come back. Or you can drive it for a about 5 heat cycles and it may reset itself.
|
I did a search and cam up with this thread...
http://www.dieseltruckresource.com/d.../t-146846.html not much info but you may able to chime in and see what the results were. |
I also found that, I have had no other problems since the codes. :confused:
|
weird... no mods either huh?
|
Not yet, I have them sitting on my desk waiting to install.
|
This one has me stumped, I will continue to see what I can find for you.
|
|
Disconnect your batterys and turn your key on and leave it over night ,
In the moring turn jkey off reconnect batterys Reset APPS and Start it up and Check for codes DM |
Originally Posted by DieselMinded
(Post 48515)
Disconnect your batterys and turn your key on and leave it over night ,
In the moring turn jkey off reconnect batterys Reset APPS and Start it up and Check for codes DM |
Resetting the APPS causes the ECM to 're-learn' where the throttle is at all times when something happens to cause the ECM to not understand what the APPS is telling it like a dirty spot or something like that. What you do is disconnect BOTH batteries (yes you will need to reprogram your radio), turn the key on and wait for atleast 10 minutes, then turn the key off and hook up the batteries. Once that is done turn the key on but don't start it yet. SLOWLY and steadily push the throttle to the floor and SLOWLY and steadily release it. Turn the key off and then you can start it. You have now re-set the APPS.
|
Thats Because PD412 Is not a Code
But P0412 is ..... and its in there :) |
Yes it is, it said PD412 not P0412. I give up with it I am bombing it this weekend.
|
May of been the tears in your eyes Bud
DM |
lol, I looked at it twice and so did another fellow gearhead. We both agreed that it was a D, but I have had no other problems withit since so I guess that it amounted to nothing.
|
All times are GMT -5. The time now is 03:27 PM. |
© 2024 MH Sub I, LLC dba Internet Brands