Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   5.9 Liter CR Dodge Cummins 03-07 (https://www.dieselbombers.com/5-9-liter-cr-dodge-cummins-03-07/)
-   -   Bucking, missing, pinging, black smoke. Help (https://www.dieselbombers.com/5-9-liter-cr-dodge-cummins-03-07/133579-bucking-missing-pinging-black-smoke-help.html)

Keeth Colton 07-22-2017 12:18 AM

Bucking, missing, pinging, black smoke. Help
 
I'll do so searching, but if anyone wants to chime in directly I would appreciate it. 2006 Ram 2500 all stock with the exception of Exhaust, cold air intake, and Edge EZ. 243k miles....

Sooo driving back home to Oregon today from Nor-Cal all is doing great as usual until major run ability problems. Here where the conditions. Cruise control set @ 70mph, 90 degrees outside, just above 1/4 tank fuel remaining since fill up in Willitis Ca. Running empty NOT hauling or towing.
So here's what happened. was blasting along, than than a huge kick like a massive cyl dump miss, than starts bucking and missing bad, starts pinging real bad, I cancel the cruise and give it 3/4 throttle the truck takes off into run-away mode gets to 85mph , large black smoke. I was about to shut the key off when it stops and calms down, but still missing. So I look at my traffic conditions and decide to lay into see see what happens, I go WOT and get a huge plume of black smoke again and massive detonation(pinging), bucking, cutting out, and again run-a-way. If i brought it down under 60 and low pedal maintenance she cruised fine, but the moment it's put under a load or heavy pedal all would start again, I was able to make it home, but there is a problem. No check engine light, no funny warning lights, water temp normal, oil level normal, and oil pressure normal.
So If anyone knows of a thread here on this please share with me or let me know your thoughts. Thanks

CumminsCoalRoller24/7 07-22-2017 09:18 AM

What level was the edge set to? Do you have a rail pressure gauge? Not sure about pinging noise, could have been a side effect of running rough but my guess is the lift pump is taking a dump and can't keep up with fueling. Have you replaced your lift pump yet?

Keeth Colton 07-22-2017 10:39 AM


Originally Posted by CumminsCoalRoller24/7 (Post 1134187)
What level was the edge set to? Do you have a rail pressure gauge? Not sure about pinging noise, could have been a side effect of running rough but my guess is the lift pump is taking a dump and can't keep up with fueling. Have you replaced your lift pump yet?

Haven't done anything yet, I don't know what direction to go in. The edge is just a EZ so it has a 3way toggle switch. I've never changed it. It's on the middle position which I believe is +100. I don't have any gauges other than the factory. Where is the lift pump located?

Keeth Colton 07-22-2017 12:20 PM

Okay, update... Figured i would remove the Edge Ez first to eliminate it as a problem... Well guess what took a shit.. Yep truck now runs great and all is well.. Edge EZ, meet the trash can.

CumminsCoalRoller24/7 07-22-2017 08:59 PM

That's the best spot for it. Do yourself a favor and get EFI Live!

chopforman 07-22-2017 10:29 PM

If your going to buy a tuner buy a smarty jr.
The support staff at smarty are so good and helpful
They will help you tune your truck the right way

CumminsCoalRoller24/7 07-23-2017 05:22 PM


Originally Posted by chopforman (Post 1134213)
If your going to buy a tuner buy a smarty jr.
The support staff at smarty are so good and helpful
They will help you tune your truck the right way

06+ TrUcks EFI Live offers the best tuning available


All times are GMT -5. The time now is 04:39 AM.


© 2024 MH Sub I, LLC dba Internet Brands