Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   5.9 Liter CR Dodge Cummins 03-07 (https://www.dieselbombers.com/5-9-liter-cr-dodge-cummins-03-07/)
-   -   smarty good for stock 48 re tranny? (https://www.dieselbombers.com/5-9-liter-cr-dodge-cummins-03-07/120285-smarty-good-stock-48-re-tranny.html)

Zak27 04-05-2014 04:45 PM

smarty good for stock 48 re tranny?
 
im looking into the smary pod s-06 programmer and i was woundering if it would be safe for the stock 48 re tranny for my cummins? what level would be safe? sw3,4,5,6?

madhat 04-05-2014 08:00 PM

The smarty paperwork says SW 3 is the highest you should go with a stock auto. I'd keep the torque management low as well. The harder you beat on it, the shorter it will live.

cerberus60 04-05-2014 08:06 PM

Consider this; you can kill a stock transmission on stock power, or, run Smarty on SW9 and not kill the trans. Short answer is a lot depends on your right foot and all the other settings on Smarty.

Basically, you could probably run SW2 and use it all without hurting things. If you try to run SW3 or higher and reduce the TQ management to where the truck responds so much better to throttle it is only a matter of time until it torches the direct clutch pack and likely ruins the input shaft.

If you want to make use of the power and the settings to optimize the driving experience you NEED to upgrade the trans to a degree. A shift kit, billet band strut and anchor, front servo cover will allow you to get pretty aggresive up to SW6 or until the TC gives up, that will be the weak point after the other smaller upgrades.

crf450x 04-06-2014 01:19 AM

Like said, it all depends on how you drive. And a huge part of it also is luck. I have a buddy with efi live and a 64 running a stock trans with 200k on it and it's still kickin. So you may get lucky....don't count on it though.

mykaos 04-06-2014 05:54 PM

Additionally to what's already been said, remove the TC Anti-drain back valve, turn up the line pressure a tad. Mine survived over 30,000 mi w/ Crazy Larry and another 4,000 mi with compounds...

Zak27 04-18-2014 11:09 PM

It's a new 48re tranny or stock tranny but thank you for the advice and let me know more please

lukesdiesel 04-19-2014 05:11 AM

Install a good aftermarket valve body and torque converter

Sent from my DROID RAZR using Tapatalk

Zak27 04-19-2014 03:52 PM

What about input and out put shaft with the valve body and tc

Bigg Redd 04-19-2014 08:25 PM

An inline auxillary trans cooler cant hurt.........to help keep trans temps in check.

Zak27 04-20-2014 10:05 AM

how well does a smarty jr work for the stock tranny? on sw3 says its 100 hp any different then the pod?


All times are GMT -5. The time now is 02:07 AM.


© 2024 MH Sub I, LLC dba Internet Brands