Hole in my block
As the title says, I have a giant hole in my block. (I think #5) I bought the truck this way, Im having a hard time finding a block to replace it. I know I have at least one bad rod and piston. I did start the motor and it ran and sounded pretty good to me. (for having a hole in the block) I only ran it for a few seconds, oil stated to pour out of it. Can anyone tell me where I can find a block? Also what blocks are interechangable? Is it only 03-07? From what I have read, the difference from the older 24V blocks is the CR blocks are stronger because of extra stiffining in the lower end. Will an older 24V block work?
|
JUST 03-07 Try ebay, craigslist and competition diesel, I have one for a grand shipped pending sale! But can find one if you want!
|
their a guy in Denver CO called Diesel Stop who rebuilds these engines, cost around 3500 for a long block you have to swap the CP3 over and the rocker arms, swinging one in for a friend and at my job we swong one in for a guy who was about o lose number 3.
|
Originally Posted by dangerous1965
(Post 1032243)
JUST 03-07 Try ebay, craigslist and competition diesel, I have one for a grand shipped pending sale! But can find one if you want!
---AutoMerged DoublePost---
Originally Posted by RanchhandTCR
(Post 1032254)
their a guy in Denver CO called Diesel Stop who rebuilds these engines, cost around 3500 for a long block you have to swap the CP3 over and the rocker arms, swinging one in for a friend and at my job we swong one in for a guy who was about o lose number 3.
|
It depends on the condition of the block if it need remachined, this was for a standard bore block, but he puts new pistons, rings, bearings, checks the front gears, new seals, and new lifters, but the push rods, and rocker arms are up to you... Rebuild kits are pretty cheap for these engines, but really those are really the main components that need replaced. Im beleive he goes thru the heads to.
|
It's a .020 over block PM me next week to see If it sold or not!
|
Did you sell the block? I dont know how to PM. Thanks Billy
|
|
Originally Posted by Wild Billls Gun Shop
(Post 1034002)
Did you sell the block? I dont know how to PM. Thanks Billy
|
Try cumminsperformanceparts.com they have rebuilt motors and long blocks for a decent price. Hope that helps!
|
All times are GMT -5. The time now is 01:05 AM. |
© 2024 MH Sub I, LLC dba Internet Brands