cummins270 |
07-10-2012 03:59 PM |
To much fuel?
I just installed an air dog 200 gph on my truck and now it starts hard or not at all when its warm. I cracked four lines and even submerged the entire suction line inside of a five gallon jug thinking it may be sucking air where I cut and spliced the hose but it still wouldn't start. I finally disconnected the line where it enters the injection pump and had someone hit the starter and the truck started fine so I connected the line back up and it runs fine. So, I adjusted the regulator all the way down and it helped but it still starts hard any suggestions? I have a fuel pressure sensor, but the wire for my edge will not reach the lift pump so I can't install it right now.
|