NV5600 Input shaft
Has anyone ever broken and NV5600 input shaft? Mabey towing a 28' gooseneck with 500hp and a dual disk isnt a good idea.:argh: Will post pics of the destruction later.
|
ouch. what were you doing at the time?
|
Post'em, I'm the same boat minus the 500 hp and DD :argh:
|
good lord! that takes some.
---AutoMerged DoublePost--- i meant to say, good lord that takes some doing! |
|
Just broke mine today pulling a 14-16,000 lb gooseneck pretty much sucks mines runnin about 425 hp 2wheel drive sb dd 3600lb plate rating :ouch::argh::td:
|
Small one or big one?
|
those shafts arent suspose to break on the 6 speeds lol
|
Nice carnage....
|
Unsprung hubs are killer on shafts and splines. My last unsprung hub in a T56 turned the input shaft splines into razor blades. I'll never put an unsprung unit in anything short of a track rat.
Need more pictures of the ends. Can't tell if it was a clean break or if it had been working on the moment of fail for awhile. Rough texture = clean break Shiny = Its been at it awhile |
1"3/8 " input shaft guy from southbend says most of these nv5600 that they see breaking input shafts are while under heavy loads higher rpms and high gear like in 6 or overdrive what ever you wanna call it which makes sense to me as I was in 6th pulling a loaded gooseneck trailer up a small grade doing 67 mph sucks to find out I'm really just a bad driver and I could've avoided this whole situation but this kinda catrastphry is not very common from what I understand :ouch:
|
All times are GMT -5. The time now is 06:32 PM. |
© 2024 MH Sub I, LLC dba Internet Brands