egt probe on edge going bad??
i have 2 egt gauges one with my edge unit and one in my pillar pod the one in my pillar pod has been reading around 300 degrees sometimes lower then the edge something tells me there is something wrong with the edge probe do these go out alot anyone ever heard of this the gauge in my pillar pod that reads lower is from glowshift:s:
|
ive heard glowshift gauges arent to accurate. so might be that probe not your edge
|
hmm maybe any other suggestions welcome the glowshift was running right like 800 and stuff at 60 on the highway and the edge was saying like 1200 constant even off the throttle for a little so idk
|
I just installed a used EJA on a diramax and ran into that problem. Read 250 before we started it and went up to 1800 when we pulled away. Switched probe with a new one and all is good. Good luck. pt
|
hmm what kinda probe did ya switch with and did u just tap into the juice wires????:choochoo:
|
Since there is a 300* difference is it possible one sender is pre turbo and one post? That could account for the difference.
|
no they are both side by side in the manifold:td:
|
All times are GMT -5. The time now is 04:50 PM. |
© 2024 MH Sub I, LLC dba Internet Brands