Diesel Bombers

Diesel Bombers (https://www.dieselbombers.com/)
-   24 Valve 2nd Gen Dodge Cummins 98.5-02 (https://www.dieselbombers.com/24-valve-2nd-gen-dodge-cummins-98-5-02/)
-   -   (beating a dead horse) trans question (https://www.dieselbombers.com/24-valve-2nd-gen-dodge-cummins-98-5-02/70029-beating-dead-horse-trans-question.html)

billyjobob 02-10-2011 12:17 AM

(beating a dead horse) trans question
 
think its solinoids in the trans and where to get the parts. tc lock un lock round 70 mph and at 40 mph turn OD off does it at 25 mph. 4 speed RE 4:10 gears 147 th miles. need to fix b4 something breaks thanks :c:

turbo20psi 02-10-2011 11:11 AM

Parts:

ElectricalAdvantage.Net - Specialty Automotive Components

Band adjustment:

94+ Ram AT band adjustment

If you want you can install a DTT noise filter.But before you do that clean and check all your grounds on the truck.
24 Valve APPS
Rewire Ground Instructions
1994+

Lock-Up-O/D shuttle/hunt

Symptoms: At steady throttle usually at approx 40-50 MPH the tachometer will rise and fall approx 150-200 RPMS as the Torque Converter Clutch engages and dis-engages.

Problem: Electrical noise in the conducting wires running from the PCM (power train control module) to the TPS ( throttle position sensor).

This may be verified by observing a scanner while the complaint is occurring. The PCM will command loc-up on &off, the transmission is only doing what it is being told. This is not a "transmission " problem. Working on the transmission will not fix the problem. The PCM reacts to monitored voltage spikes caused by the TPS power and signal wires picking up electrical noise from other wires in the harness. The primary culprit is the AC voltage produced by the alternator. Replacing TPS’s,sensors, or PCM reflash almost never fixes the problem.

Solution: Make sure both batteries are in good condition. Make sure all battery cable connections are clean and tight. Make sure all ground connections are not corroded, this applies to PCM, TPS, and all ground connections on chassis and engine. After rewire it is sometimes required to "re-learn " the TPS (APPS on 98.5 +). Here’s how: disconnect both batteries for 15 minutes, reconnect batteries, turn ignition switch to run position (do not crank engine), slowly depress the accelerator pedal to the floor and release, turn key off. Now you may start engine and road test to verify complaint is fixed. There is a very rare occurrence of the PCM itself being defective, this is the exception not the rule. Try the most economical fix first!

A weekend and a filter ,ATF+4 and you are on your way.


All times are GMT -5. The time now is 06:31 PM.


© 2024 MH Sub I, LLC dba Internet Brands