Im trying to launch it at 20 psi but it wont let me go past 10 without defueling
|
The RAD box will work for your truck. It makes the ECM see 55MPH at all times so it doesnt defuel at any boost level.
|
Are you sure the ADR w/ Pulse doesnt get rid of it? I will have to try it tomorrow but when i power break it i normally ignite the tires...
I have did it to get a picture once in 4wd it fueled hard... Too hard... It actually stalled out when i got off throttle! LOL! :humm: |
the adr should get rid of it or atleast i know the adr 4k does. mine will tag 20 psi in nuteral, just reving the engine. and that is on a mechanical boost guage not the adr monitor. the smarty on the 99 will also remove it. and the 99 is a lot different than an 01 02 truck it doesnt have the same tqman that they have. 99 are striped down on the electronics side of it. i mean the dont have a speed cut off like the 00-02 does just a defuel point. so its kind of hard for you guys driving the 00-02 trucks to compare to the 98.5-99 trucks. and unless you have billet shafts in your tranny and a billet flex plate i would not go above 10psi on a launch. it will shear the shafts at that boost level. thats where the tqman is handy cause it will help save the trans and keep you from exploding it.
|
my stock output made it till 600hp and then blew. was doing 20psi launches for a year and a half then went compounds and bang
|
well yours made it better than mine. i broke 4 of them boost launching. and one input on a roll race. and 2 flex plates. the last flex plate was a billet one and i still twisted it in half. and 600hp is that by your estimates or a dyno proven number. because acording to sun coast and ats a stock shaft is only capable of 450.
|
Im sure a tranny parts company is gonna under rate parts to sell theirs or make theirs more appealing.
I definitely dont have a SPEED defuel. Been over 115mph hehehe! :yeah: |
Originally Posted by banditsdiesel
(Post 698249)
well yours made it better than mine. i broke 4 of them boost launching. and one input on a roll race. and 2 flex plates. the last flex plate was a billet one and i still twisted it in half. and 600hp is that by your estimates or a dyno proven number. because acording to sun coast and ats a stock shaft is only capable of 450.
|
All times are GMT -5. The time now is 12:28 AM. |
© 2024 MH Sub I, LLC dba Internet Brands