If the lift pump runs fine while it's hot wired then the problem is the ECM. You need to have it checked at the dealer, if all goes well they can just re-flash it and all will be fine.
|
Hey guys I think I may be experiencing a similar issue with my lift pump. I just spoke to the local dealer about reflashing my ECM and his response was that as soon as I plug the Edge Chip back into the truck it will override the flash and any updates will be for not. Is this true?
|
Originally Posted by kpcoupe
(Post 355771)
i have hot wired the lift pump and it does fine. does that mean it is the ecm?
there are actually 2 feeds for the lift pump, 1st is 100% duty cycle for starting second is 15% for normal operation the circuit is K135 and the wires are both yellow with white stripe they come together at splice S160 and it sounds like your 15% duty cycle is falling off they are in 15 and 35 in pcm connector this does not eliminate the possibility of a sick pcm a reflash might fix the issue but I wouldnt hold my breathe pcm is burnt with the vehicles VIN so i dont think a swap with a used one will work, but you may be able to overwrite the pcm VIN good luck scott:hellox: |
i had the same dealer and it was a ground wire on pass side battery was broke and touched sometimes and sometimes wouldnt i put a new eyelet on wire to post worked ever since!!!!
|
All times are GMT -5. The time now is 03:56 PM. |
© 2024 MH Sub I, LLC dba Internet Brands