Diesel Bombers
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page

Diesel Bombers (https://www.dieselbombers.com/)
-   24 Valve 2nd Gen Dodge Cummins 98.5-02 (https://www.dieselbombers.com/24-valve-2nd-gen-dodge-cummins-98-5-02/)
-   -   Fuel Pressure (https://www.dieselbombers.com/24-valve-2nd-gen-dodge-cummins-98-5-02/27045-fuel-pressure.html)

coyropin 05-30-2009 06:50 PM
those codes came up with p1689 traction control delivered torque output circuit po382 glow plug/heater circuit "b" malfunction

Uncle Bubba 05-31-2009 02:34 AM
Originally Posted by kpcoupe (Post 342232)
sorry code was 1693 not 1689

---AutoMerged DoublePost---

so i went out and hooked a jumper wire strait to the lift pump and would only get 6 lbs fuel pressure as soon as i would start the truck the pressure would drop down to between 0 and 1 so i shut it off then i hooked it up to both the lift pump and the carter 21 lbs of pressure and i started the truck she ran like a champ and held a constant 21 lbs for at least 15 min with no problems. does this mean my ecu is bad. i have all ready checked the relay and replaced it.
This means that you either have a bad ground or the computer is bad. Time to get the Voltmeter out and check the grounds, if they all check out then it needs to go to the dealer so they can run a diagnostic on the puter. There are some codes that only there scanners will find. But you are lucky in the fact that your truck is in the years that Cummins can still work on so you aren't stuck havin to use a Dodge dealer.


All times are GMT -5. The time now is 05:37 PM.
Page 2 of 2
1
2
Show 40 post(s) from this thread on one page


© 2024 MH Sub I, LLC dba Internet Brands