help
yes i have 1998 dodge 2500 24v cummins turbo diesel it will turn over but wont start i ran it out of diesel about 6 months go and i when to start it today after putting fuel in it and bleeding it out and i have 12 psi of fuel pressue still wont crank but it will start with ether and then die after it burn all the ether
|
How did you bleed the line? You should pull off #1 and #3 fuel line off head then crank over till fuel comes out of those 2 and then re install
|
I bleed #1 #3 #5 turn it over til fuel came out and til air bubbles was gone then tighten them back down
|
Try bleeding air out of the filter housing first then do injector lines. Just loosen banjo bolts and turn key on to get pump working to push air out
|
OK I have did that and still the same thing turn over and No crank just turn over and over
|
Curious if a sensor is causing the issue like crank position
|
very well possible I have to check them tomorrow
|
All times are GMT -5. The time now is 04:16 AM. |
© 2024 MH Sub I, LLC dba Internet Brands