truck died and won't start
my dad started his truck this morning and after about a minute it died. it ran fine right up until it died. when it died it did not stumble, smoke or anything. it just shut off like someone turned the key off. it is completely stock other than a F.A.S.S. system and a small programmer. where do we start. I don't know much about vp44 trucks
|
check fuel psi and check for codes.
|
check the pressure like doll_hite said one of the pumps prolly shit the bed iv never really heard of one just bam no sign of going out but i would say start there for sure the lift might have went out or just seized or was going out and fried that vp maybe hard to say with such little symptoms
|
How much fuel is in the tank?
|
def check the fuel level! never fully trust the fuel guages in 2 gen trucks!!
|
the tank is full. the only code it is showing is p0234. which I believe is over boost. so that shouldn't have any effect. does the vp44 have a shut off solenoid that could have possibly gone bad
|
If the horn works swap the horn relay and fuel relay. If you bump the starter the lift pump should run for about 25sec. Can you hear it running? If so, loosen injector lines 1,3,&4 at the head and see it you are getting fuel to the injectors.
|
All times are GMT -5. The time now is 07:58 PM. |
© 2024 MH Sub I, LLC dba Internet Brands