Check Engine Light
#1
Check Engine Light
I bought a 1999 Dodge Ram 2500 in April 2012 with 134k miles. The other day the check engine light came on and lost power, this sounds like a common problem. Changed fuel filter and the check engine light went off and it ran great. The next day started it and was letting it warm and I noticed a miss in the idle. Took off and it seemed fine, a couple of miles later the check engine light came back on and lost power. I could not get above 35 mph, also noticed that the lights were bright until I stepped on the throttle and they would go dim???
#2
#4
#5
Check Engine Light
I bought a Actron AutoScanner OBD II Scan Tool CP9575 these are the codes that it showed P-606
P-234
P-123
P-382
P-121
What does this mean ????
---AutoMerged DoublePost---
PO-606 = Electronic Control Module Malfunction
PO-243 = Turbo boost limit exceeded
PO-123 = Acceleration Position Sensor Signal Voltage Too High
PO-382 = Intake Air Heater Relay 2 Control
PO-121 = Acceleration Position Sensor Volts Do Not Agree With Idle Valid Signal
P-234
P-123
P-382
P-121
What does this mean ????
---AutoMerged DoublePost---
PO-606 = Electronic Control Module Malfunction
PO-243 = Turbo boost limit exceeded
PO-123 = Acceleration Position Sensor Signal Voltage Too High
PO-382 = Intake Air Heater Relay 2 Control
PO-121 = Acceleration Position Sensor Volts Do Not Agree With Idle Valid Signal
Last edited by sjrvan; 12-26-2012 at 11:16 AM. Reason: Automerged Doublepost
#6
#7
#8
#10