BIG RON |
12-13-2010 08:17 PM |
Mine did the same thing a while back,i took the snap ring out and found that the shaft on the stick that goes down in the tranny had broke off before and had been poorly welded back on and had bent over a little. There is a small tit sticking up between the shift levers, with the bottom of the shifter being bent it was hitting this little tit and causing it to hang or not go into gear at all unless moved just right. I took and grinded the bad weld completely cleaned it up good put it back in straight position welded grinded back down flush problem solved. Maybe what that one is doin.
|