VE PUMP LEAK
I developed a fuel leak on the pump and it seems to be coming from a bolt that is facing the timing case right under the little steel line that comes from the KSB. right where the ksb line almost touches the timing case the bolt is right under it. Any ideas? does this require pump removal to fix?
|
Wow! Some one with the same problem that I thought I had!
Check the line that goes in just to the lower right of it first! I pulled my motor based on the fact that I thought that was leaking and thought the flex plate was chipped. Both weren't the case. So even though that might look to be the prob CHECK ALL OTHER POSSIBILITIES FIRST. Don't want ya to pull everything apart if ya don't have to.:tu: ---AutoMerged DoublePost--- Oh I do apologize, it is the governor shaft that MIGHT me the cause.:argh: |
read last line first
it's not a bolt just a nut of the end of the shaft that the governor rides on you have to pull the pump to fix it (o-ring) remove front shaft cover remove nut and lock washer from the pump shaft DO NOT DROP WASHER IN THE FRONT COVER!!!!!!!!! rotate motor until the key is located at 12:00 use puller to remove gear from the shaft scribe the shaft end to mark the location of the key!!!!! (this will make you a happy camper when you go to reinstall the pump) beats the S out of knocking the key out and having it fall inside the cover??? remove injector lines remove fuel lines (supply and overflow) remove throttle linkage 911/2 to 93 models with automatic? if so these will have a tps plate that mounts on the top of the pump if you disturb the tps the transmission will have shifting problems if so when you remove the supply line do it at the joint that is towards the fuel filter remove the pump's rear support bolt there are three bolts that hold the pump to the front cover pick your poison on how to remove them i remove the two bolts on the vacuum pump drop it out of the way then the bottm bolt is a walk in the park now the pump is ready to remove and fix the fuel leak loosen lock nut, use allen wrench to back the shaft out only far enough to replace the o-ring DO NOT REMOVE THE SHAFT!!!!!!!!!!! if you do that will cause the governor assembly to fall into the pump then you are really in the S after you have done this the challenge might be to find the correct o-ring ps if you are lucky and find the correct size o-ring the leak will be reaired if not you will be just slightly PO due to the exercise you just went through the above is not for the unskilled wrench knuckle buster this is just for guide lines for the a leak repair not intended to replace or modify bosch pump repair procedures!!!!!!!!!!! |
wow, this is starting to sound like a job for the local diesel shop. i wonder how much they will charge to fix it. thanks for the info:c:
|
All times are GMT -5. The time now is 06:16 PM. |
© 2024 MH Sub I, LLC dba Internet Brands