Help identify this sensor
 

What sensor is this? Would like to remove it and use that location for the exit tube on my remote oil filter.

https://cimg1.ibsrv.net/gimg/www.die...57e0940efc.jpg

Oil pressure sender for a gauge or a shutdown system.
By remote filter do you mean a bypass filter?
That line is too small for a normal full flow filter.

Yes, bypass filter. I am planning to use the port on the oil filter housing for the input into this bypass filter but need a port for the filtered oil to drain into. Was hoping to drain the oil where this sensor is located but that's not going to work if it's a oil pressure sender.

Do you have the plug in the side of the oil pan? Could go back into there. Usually used for a heater or temp gauge.

I looked for one but did not find one. Bummer. :dang:

Any other ideas for the exit line from my bypass filter?