MudDrivermike |
01-01-2014 11:08 AM |
Think I screwed up????
Just to get some feedback. On a previous topic of mine i had an isuue with what I thought was an IP issue. Either way I got everything close to being back to normal by turning up everything more than I had it before the issue. One thing I just realized I did, I messed with the overflow valve.. When I was trying to figure out the issue, I found some rubber in the screen in the overflow valve. It wasnt new from when I rebuilt it. It was something old prior to that. Anyway, I was trying to clean it out with a pick and ripped the littte screen inside. So my bright idea next was to remove the beat up screen. So I got a drill bit and took EVERYTHING out of the valve. So now its basically a banjo bolt..I didnt realize that the center was a metered oriface to keep a certain amount of fuel in the injection pump. My question is,,,,will this affect the performance of the pump. Even with everything cranked up,its not 100%. And Im wondering if this is a big deal. If this can cause an issue then Im going to replace it ASAP. Thanks In advance ..Mike:tu:
---AutoMerged DoublePost---
Dam...... Nobody?????
|