new truck leaking injection pump
 

So I couldn't resist buying another old 12 valve it's old beat and hammered 2wd auto 92 with a newer transmission. Drives fine runs good paid 800 for it and hauled it home. Injection pump is leaking pretty bad from the bottom and some from the top. I resealed one on another 12 valve I have it was leaking from several of the top end gaskets. I was afraid to go deeper. I am very mechanically inclined but don't do well with smaller fine stuff. So I can either buy another reseal kit for 20 dollars and try and go deep to get the bottom seals or there is a guy on ebay that reseals and tests them for 200 dollars plus a little for shipping. Anyone have any experience advice or other ideas. thanks.
I'm not looking for a power house already have one I honestly want to make this into a mileage truck and try and do a waste oil burner go back and forth to work 40 miles. Starting to set up my system shortly. Have a good hx35 for it already too.

I dunno, take the AFC housing off replace that gasket and the power screw oring and see what it does then, it can't hurt to see. :)

It's coming out the bottom I can't honestly tell where it's coming from. The last one I could see it coming from the housing o ring.

---AutoMerged DoublePost---

Also there is a little drip from the little vent thing from the top. But most of the fuel is coming out the bottom.

Get a reseal kit, and install a gov spring while fixing your pump.

Ya guess l just do it already got the 3k gov spring from an old project.