make my own kdpfix kit
 

I am planning on fixing my kdp in the next month or so.I hve looked on line at the kit.Its like $105 and I cant really understand how it could cost so much.its like $30 for just the gasket and it seems like I could make the cover.is that feasible?is there anything else I need?

Yes, you can definitely make the little "tab." You could also just peen over the hole. As far as the cover gasket, I just used grey permatex. While I had the cover off, I replaced the crank seal.

Note to self buy new crank seal.ok thanks for the input man.

Sure thing. :tu:

Don't forget to take out the case bolts and locktite them. Mine were all finger tight.

I ground down a fender washer that fit the bolt, it was plenty big enough to cover the dowl pin. Pretty simple fix, much cheaper too