Push rod cover/ tappet cover help
Iv got a leaking tappet cover an don't know if I'm going to be able fix it with the pumP on the the block. Looks like a tight fit to me. Or would maybe pulling the head make it possible to do? Who's done it before? Thanks, Cameron
|
u either have to pull the head, or pull the pump. pulling the pump is alot easier and cheaper. the gasket is only like 15-20 bucks at cummins
|
Ya but then u have to retime it don't you? An pull off the front cover again :argh: may be just easier to wait till I do studs. Do I have to pull the head off for arp studs?
|
u do not have to pull the front cover off. it dont take but a few mintes to time a motor. imo, there is no need to pull a head to do the side cover gasket. u would be wasteing a perfectly good gasket. but thats just my opion. good luck with it though
|
If you go the pump route don't u have to pull of the front cover to undo the nut that runs the pumP? Ya I know setting it to stock is easy but I'm running 16* timing an if I had to do it again I'd bumP it up to 18 so I'd have to do the whole dv dial meter an loctite on the gear again. Wouldn't I? Is there enOugh room to pull out the cover with the pump an head on? Or does one or the other have to go?
|
Pull the oil filler off and the nuts right there.
|
Ya but how do u bump up the timing with out pulling the cover? Iv read an never heard of this being done. Is yours a 12v or 24v?
|
There's enough room to pull the gear forward with the cover on.
|
You can time it with the cover on. Not hard at all. :c:
|
i just changed my tappet cover gasket an yes you have to pull the ip pump off to do it, and no you dont have to pull off front cover to time the truck i just did mine
|
Thanks for all the info guys much appreciated. Hope to do it this week since I need to pull my radiator out anyway cause of a leak.
|
well just to clear up things on this topic i am new here and did the conversion on my 89 suburban a few months ago and the side cover was leaking so i decided to tackle in last night! I had to remove the inner fender well fuel filter, throtle brace bracket fuel pump,(not injector pump) and the power stering and vacume just for more room and i got it changed without pulling the injector pump!!! oh boy what a bitch but it ncan be done without the ip being removed!! the plastic cover came off in pieces but i hear thats norm! took 4 hours but its done and no leaks!!:jump:
|
All times are GMT -5. The time now is 04:25 AM. |
© 2024 MH Sub I, LLC dba Internet Brands