wheel bearning
how hard is it to do a wheel bearning on 1994 3/4 ton pick up longbed dodge
|
4x4 or 2wd?
|
not to hard if u stay with it. just take ur tire off. take ur caliper off gonna need a hammer and a screwdriver. knock the big bolt loose. ur whole wheel bearing should come rite off. ur rotor is gonna be attatched till u tap ur studs out. then its good to throw in the scrap pile. be sure u hit the studs rite or u will be doin some filin or buyin.:tu: good luck should take about a hour each side. mite as well check upper/lower ball joints while ur in it. get moog
|
Text sent
|
If yours was like mine, my whole wheel bearing with rusted and plain stuck in there. But i took a socket and used the powersteering pump as a press and took it out. and got some sandpaper and cleaned it up a little and putted the new one! but when you start driving your truck again, just be sure to retorque thoses studs and make sure they seat properly:yeah:
|
My driver side was a b!tch. I tried the steering and socket thing but all I got was PS fluid on the flooor. (Gear box is about shot) I used a 2 pound hammer and hit the rotor till it came out. One way or another it WILL come out. :c:
|
NO GOOD!! how are you pressing it? tapping it or just turn it wide open?
|
All times are GMT -5. The time now is 12:38 AM. |
© 2024 MH Sub I, LLC dba Internet Brands