I just tabed my kdp and I thought if anyone had any questions I'd love to help out since its all fresh in my mind.

I used the directions at tstproducts.com and they were very complete however I didnt use their kit I got the seal kit, gasket and longer bolt through Cummins Mid-America. I cut the tab from a 2" fender washer and used the pattern on dodgeram.org

I had to go a little above and beyond (I tend to ).....I painted the cover and rpm sensor hardware flame red to match my truck (I think it turned out magnificently)

Hope I can help someone,
Justin

 

You will sleep better for sure.

Hope you put loctite on all the other bolts under the timing case cover.

 

sleeping like a baby for sure
and yessir I did.....loctite and torqued to spec
Justin

 

did you take pictures if you did post them up and make a write up

 

well darnit no I did not.....wish I could have done that. Perhaps I will do that with my next project
Justin