Oil Pan Replacement
 

I need to replace my oil pan. It is possible to get it out by just raising the engine, or do I need to pull the trans? All the steering linkage is out and the axle housing is just hanging, so I have some wiggling room.

I'm not sure about not pulling the transmission, but you might just be able to do this - I'd try it anyway. Save you some time

There are only 2 motor mounts holding the motor in, you may have to take the trans crossmember bolts loose but it sounds like its worth a shot.

I think if you lossen the tranny mount bolts and the motor mounts, raise the motor up a little bit, you should be able to get it out. It just really tight.

undo motor mounts and raise the engine up exactly four inches. no more. make sure its secure.