Intake Horn
i found some 1/4 inch plate and 3.5 inch tubing in my garage. i was thinking of making a custom intake horn for my truck.any thoughts positive negative?
|
Won't hurt, might help. Go for it. Make something like this; PUSHER ALUMINUM Dodge Cummins 12v Intake Manifold Horn - eBay (item 220477841796 end time Nov-06-09 19:28:29 PST)
|
would one really lower egts 50-100 degrees?
|
more air flow; its entirely possible. you may notice boost pressure may drop; but it takes a restriction to create pressure. by cuttin the intake loose your reducing restriction and increasing flow. all of which can and will help egt's
|
so what do you think about the cfm+ intake elbows? poor investment as far as mods go?
|
every one on here says there not worth the 300 400 bucks but idk 160 for one seems worth it
|
so is the pusher intake elbow pretty much the same as the cfm, bladerunner,or bullydog but half the price?
|
Air Intake Horns=Lightened load in your wallet with minimal gains for your motor.
|
hom many horses would you even gain if any?
|
loss in pressure but volume would stay the say so would hp numbers correct?
|
All times are GMT -5. The time now is 12:40 PM. |
© 2024 MH Sub I, LLC dba Internet Brands