so im getting some gauges in the mail soon (egt, fuel pressure, and boost)
so i need to make sure im drillin n tappin in the right spots..
egt i was thinkin pre turbo?? or is post turbo better?
boost and fuel press i have no idea...
thanks
bob

 

Pre turbo is the only way to go. We always use a vac to suck out the particals we can, then start the truck without the probe installed. The hole provides less resistance than the charger, The flakes will come out the hole. Not to mention there should never be anything big enough to cause problems in the first place. I always center punch, Small bit, then a 21/64 bit

The common place for a boost gauge is under the fuel lines. You'll find two 1/4 (IIRC) ports , the one closest to the front of the truck is most commonly used!
Fuel pressure...What gauge do you have and I'll give you some ideas!

 

the fuel pressure it from auto meter... thats all ik... haha ask luke... thats were i got them from... and where on the fuel lines are you talkin about exactly?? close to the injectors or closer to the fuel filter?

 

It will be between the pump and head, under injector lines. Some folks get pressure off the fuel filter housing, thats the cleanest install that I've seen yet on a truck with factory fuel filters!

 

and how do you exactly do you do that?? drill n tap?? ive herd of some guys buyin a fuel tank cap thats got a hole drilled n tapped for it?? but that doesnt sound right to me maybe im wrong

 

The fuel filter housing has a banjo bolt that can be changed for a version with a 1/8NPT port in the top of the bolt IIRC that allows you to get fuel pressure at the entrance of the fuel filter. I'm sure some of the guys that have done it will drop in soon!

 

yes drop in guys... ahhah also if nybody know where to get the "special" banjo bolt that would be helpfull!!
thanks dudes...

 

genos will have it look at there page on hear

 

i just did n they have nothin for the 95 dodge
http://www.genosgarage.com/products.asp?dept=63
ny where else i could get somethin??

 

The Isspro Gauges will come with the Banjo Bolt.