More power!!!!
 

Hey guys, I have an 06 F350 4x4 dually that came with a boat anker better known as a 6.0 powerstroke. My truck made it to 105k and the motor locked up. Naturally Ford wouldn't fix it ( all the while agreeing that it was junk ). So, I bit the bullet and did the following. 94 12valve cummins conversion kit, .40 over, stage 3 injectors, 64mm Phat Shaft turbo, fuel plates, transmission rebuild with bullet prove low stall converter, hardened input shaft and shift kit. 10" lift with 22.5 Alcoas and 6" straight exhaust.
What else can we do to get more power for little money, as my bank account and wife's patience are dwindling.

Get rid of the lift and over-sized wheels and tires....You gain hp and get paid when you sell the lift, wheels, and tires....:w2::pca1:

I agree but done gone to far to go back now lol.
I have changed the ring and pinions from 4.11 to 5.88's so we will be good as far as ratio power/torque. Thanks for the thought though.

Worth a shot....lol

Upgrade to compounds and add more fuel my friend. :c:

what is your timing at:hellox:

Well, you certainly improved the ford by putting a Cummins in it!:tu:

4K gsk and 60lb valve springs will really wake them up...:c:

I didn't think to ask, have you done any pump tweaks?

4ks 60lb springs and bump your timing! the 4ks do a world of a difrence! it will feel like a new truck

I had a certified cummins mechanic, who is a buddy of a buddy, come over and tweak the timing. I wanta say 3 degrees. He also put the hot rod plates in the pump as well, set wide open. I should let everyone know, iv not even started the motor yet. Iv tried to upload pics but have been unsuccessful. The motor, tranny, transfer, d:argh::argh:rive lines and 6" exhaust are all bolted up. Valve covers and air horn polished, airconditioner lines, fuel lines, trans hoses and steering pump lines are fabbed and on as well but still have to finish my steering column u joints and buy new billet radiator and intercooler.

---AutoMerged DoublePost---

So the 4ks 60lb springs really help? How much $$$ ?
Brand etc? Should I purchase new cables for the pump? I heard that they wear alot causing you to lose travel at the pedal, when you gotter WIDE OPEN.

---AutoMerged DoublePost---

I can't figure out how to get these pics attached :argh:

It can't hurt to replace the cables. Far as brands to get check out what our vendors have to offer and do some research. That is the best way IMO, everybody will have their preferred brand but that doesn't mean it is the best bang for your buck. :c:

I'll do that. I can't wait to getter done and roll alittle coal!!
Say, do you no how to upload photos to this site?
Thanks!!:tu:

If u have photobucket upload the pics there then go to the pic and right click and go to properties and get the URL code and then come backe to dieselbombers and click the pic icon with 2 mtns and the sun and paste the URL code:rocking::argh:

Build yourself a set of compounds... HX55 under the stock charger will work good, if you do want more you can always build the same setup i have... 16cm2 HX40W & 32cm2 HX60 :)

Hey Angelic0,

Two questions, Hows your foot?
And, have you adressed the fuel issue on your truck and turn Iceland into mulch yet??

Water meth will keep you cooler and get you a few more HP

Foot is good enough to stomp around with black smoke tailing me everywhere...

Good enough for a 4th gear rolling burnout that ended with a disaster, i guess i'll be swapping that D80 rear in sooner than expected :')

:lol88: Aw shit......I guess that answers that!!!!!