Help Please!! Truck dead!!
 

I have 2011 ram 6.7. I recently installed a tbe exhaust on and tried to install new mini Maxx. During install it froze up on 49% on the writing engine screen . I left it for over an hour and turned off truck and unplugged unit and tried to install again and now it freezes on preparing to intall do not unplug screen. All dash lights are lit up check engine, trailer brakes, 4x4 etc and now truck won't start. Truck has been like this for a month. I sent tuner back and got a new one that hasn't left the box. Towed to one stealership and sat for 3 weeks without them looking at it so towed to another. I told them just to flash back to stock. They said that all wiring checks out fine but the ECM will not communicate. They tell me it's done and cost a pretty penny to replace with them doing it.

Should I get a second opinion on this or is it pretty much my main problem?

Does anyone know where I can order one for a less price than the dealer?

2011 ram 2500 6.7 longhorn auto trans

Thanks in advance.

i guess nobody is here. my questions go unawnsered as well.

Ebay dude. I found a 2010 auto trans for 220 used. Make sure you match the part #'s and get that beast back on the road. Says it will have to be reflashed for new install but better than new price I'm sure!

P0193 Fuel Rail Pressure Sensor Circuit High Input, i have had this code for more than a month no. i have a 6.7L EGR/DPF delete with a smarty tune. I've replaced the FRS that didn't fix the prob, i shimmed my release value now it has a lupe idle i believe its called.

any help would do!!