like title says. im trying to decide if i want to build my own kit or buy one.

i could use pictures from every make and model truck and manufatures bars

hell if you built your own kit i want to see those too.

if this gets big enough i will make this a sticky

thanks guys

Superstroker10's Sig:

Early 99 CCLB Phantom II'sX4
What im Running: DP-f6,Terminator Engineering HPOP's, Built Trans with Billet T/C
350cc Bcodes
NEED: MODDED H2e

2008 F250 RCLB
4WD 18" Mamba M2-8's
New: SCT W/Innovative Diesel Performance Extreme Tunes
flowpro 4inch dpf,Doc delete
Dirty Diesel Customs 3inch SS intercooler pipe
ZEX

anyone??

im workin on gettin a set custom made if they get done ill get em on here

research torque arm setups like a factory 4th gen camaro just a little more heavy duty haha its like a single ladder bar that attaches to the rear on the pumpkin area and has the pivot point in the front very close th the front u joint on a cross member if there is one there make brakets if not build a crossmember outof some 2x2 heavy wall steel this allows for lots of suspension articulation and wont bind up if you get into the rough stuff but will keep the rear axle under control
TCP Rear Pushrod Suspension Kit

I'll post my pics of the ones i built when i get them back from being powdercoated.

chevycummins1@yahoo.com's Sig:

1995 CHEVY WITH 12 VALVE CUMMINS