Replaced O-Rings on HPOP now it wont start
#1
Replaced O-Rings on HPOP now it wont start
So I took my HPOP out put a new o-ring's on it and the IPR re-installed it, now no start. Its throwing code P1212 and P1280. When it is cranking over the oil pressure gauge will be low then jump up to normal. Please help
Last edited by JPT99; 08-15-2014 at 06:29 PM.
#3
joebob- i cranked it until the batteries went dead yesterday, i plugged it in last night thinkning a hot engine would make it start easier, i put brand new fresh batteries in and i just cranked it for about 15 seconds 2 separate time. its cranking at 200rpm, the oil psi guage starts low then jumps to normal after about 5 seconds of cranking.
Thread
Thread Starter
Forum
Replies
Last Post
ebg2g
5.9 Liter CR Dodge Cummins 03-07
1
03-29-2015 06:15 PM
ninetyoned250
1st Generation Dodge Cummins 89-93
3
03-01-2015 09:10 PM
ronstop
5.9 Liter CR Dodge Cummins 03-07
0
02-26-2015 09:48 AM
carid
Diesel Bombers Sponsors
0
11-18-2014 06:49 AM