Ford Powerstroke 99-03 7.3L Discussion of 99-03 7.3 Liter Ford Powerstroke Turbo Diesels

EGTs and tranny running too hot

Thread Tools
 
Search this Thread
 
  #1  
Old 07-27-2014, 09:32 AM
play_dirty's Avatar
Diesel Fan
Thread Starter
Join Date: Jul 2012
Location: Temecula, Ca
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
Default EGTs and tranny running too hot

I have a 02 F350 that seems to get really hot really fast. When it is empty it usually sits at about 800 degrees (EGT) and between 120-180 (tranny) at 75 mph. However going up steep inclines (6-7% grades) puts the truck closer to 1000 EGT and 190 tranny, especially when climbing for long distances. If I put any weight behind the truck it gets there much faster. While towing a Nissan sentra on a tandem axle open car trailer between San Diego and Vegas there is a section of I-15 that has roughly a 5% grade you have to climb. I ended up getting to 1100 degrees EGT and 200 tranny. At first I assumed it was the ambient temp (90 degrees) but I encountered the same issue later on in single didgit temps going through the Colorado Rockies. I know DP tuners run a little hot but this happens when I'm in stock mode as well. I ended up having to slow to 50 mph both times to keep it at 1100 degrees. Is there any way I can lower my temps while towing without breaking the bank?


Truck has AFE cold air intake, BD turbo, MBRP 4" exhaust and a DP tuner with econo and performance tune. I also have bypass oil filtration and an auxiliary tranny cooler installed running schaffers 9000 oil.
 
  #2  
Old 07-27-2014, 01:35 PM
joebob3093's Avatar
Moderator
Join Date: Jul 2008
Location: Powell Butte, OR
Posts: 2,558
Received 138 Likes on 122 Posts
Default

I would check for a boost leak
 
  #3  
Old 07-27-2014, 10:36 PM
play_dirty's Avatar
Diesel Fan
Thread Starter
Join Date: Jul 2012
Location: Temecula, Ca
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
Default

This is probably a dumb question but I'll ask anyway. Is there any special tool I need to test for a boost leak or is it as simple as putting my hand near the pipes and feel for air?
 
  #4  
Old 07-27-2014, 11:23 PM
joebob3093's Avatar
Moderator
Join Date: Jul 2008
Location: Powell Butte, OR
Posts: 2,558
Received 138 Likes on 122 Posts
Default

Your going to need to pressurize the system otherwise you can't find it. You can make a piece you can clamp into the inlet of the turbo and hook an air line up to it. I wouldn't use more then about 30psi though
 




All times are GMT -5. The time now is 12:41 AM.