The Kubota Swap 'Hijack Me' Topic
#181
Something i may offer as well is a round plate that bolts to the kubota that you install your clutch put the trans into the clutch and pilot bearing , then drill you own bellhousing bolts with a hand drill . I just cant make adapters for all transmissions and it saves you most of the work ,
I acutally have my mind of making a header that is turbo friendly .. Im just not likeing the look of the turbo on top ... looks too cluttered .
I acutally have my mind of making a header that is turbo friendly .. Im just not likeing the look of the turbo on top ... looks too cluttered .
#182
#183
IM working on a couple things . its really hard to make a adapter if you dont have a trans you can fit it it to . put it all togther and make sure it works right . I dont have a 4.0 trans laying around .. I will try to find one , but i also need to find another v2203 and just isnt any forsale here local ,,
As i type Im haveing the waterjet place make me up a manifold plate . so i can make a turbo header .
As i type Im haveing the waterjet place make me up a manifold plate . so i can make a turbo header .
#184
Well if anyone is interested I have a SBC adapter on the shelf ready to ship at a discounted rate. I am redesigning the SBC adapter to use a heavier flywheel and different starter and will the producing the kits again once proven out.The new flywheel weighs in at 52lbs and holds a 12inch clutch, instead on the 168 tooth at 28lbs. This should greatly reduce vibration and driveability will greatly improve, especially when you are trying to cruise in the 1600-1800 range. Probably overkill for the Kubota but longevity of clutch, starter and flywheel will improve.
Also as a teaser I am working on a full assortment of adapters for the Isuzu 4bd motors.
More to come...
Wild, looking forward to a turbo header for these. I have made the flanges and planned on a turbo manifold but found a killer deal on 2403t manifolds a while back and bought a couple, this sidelined my header project.
Also as a teaser I am working on a full assortment of adapters for the Isuzu 4bd motors.
More to come...
Wild, looking forward to a turbo header for these. I have made the flanges and planned on a turbo manifold but found a killer deal on 2403t manifolds a while back and bought a couple, this sidelined my header project.
#185
#188
More info in case anyone else is looking for it.
This is a Delco 12SI alternator using a 4040450 4 rib belt.