Need help fast on ball joint/hub removal
#1
Need help fast on ball joint/hub removal
I have been fighting with getting the hub to seperate from the knukle on a 01 ram 2500 but I can not get to budge at all!!! Is their a trick, or some thing I am doing wrong or missing I tried a hub puller and hitting it but NOTHING works I found a how to but it is for a ram 1500 any help would be kool.
#2
A deepwell socket between the hub and axle housing. With the front end in the air, start the truck and then turn the steering wheel. the power steering will pop it right out as long as you have all the bolts loose. Your gonna fight yourself to death with a puller.
If this doens't work you still got bolts holdin it.
If this doens't work you still got bolts holdin it.
#4
Should be a spot right up there in the knuckle/U-joint. Just put it between that U-joint and the housing behind it. You might need somebody to hold it while you turn the steering wheel into it. Just make sure they move before you put any pressure on it cause it will pop out when it goes..
The following 2 users liked this post by Uncle Bubba:
01Diesel Bomb (05-20-2007),
DB Admin (05-20-2007)
#6
Same place I learned it, we just pass it on the same way somebody was nice enough to do for us. Congrats on savin a few hundred dollars.
Thread
Thread Starter
Forum
Replies
Last Post
nickpro902
Diesel In Distress - Support Ticket
1
03-14-2015 08:46 PM