Transmission HELP!
#1
Transmission HELP!
So i am looking at buying an 03 Chevy 2500 but it is throwing a pressure sensor code from the trans. But the real issue is that it will only drive a few feet in drive then kick out of gear, but will drive in reverse. I want it and I am getting an amazing deal on it but please help.
---AutoMerged DoublePost---
up
---AutoMerged DoublePost---
up
Last edited by duramaxdave; 09-22-2013 at 12:27 AM. Reason: Automerged Doublepost
#2
Join Date: Dec 2010
Location: Fool's Golden State
Posts: 1,190
Likes: 0
Received 113 Likes
on
109 Posts
sounds like the pressure switch manifold (or more likely the NSBU switch - Neutral Safety Back Up) has gone kaput or a bad wire.
the NSBU is easy to replace and fairly cheep
more info: Question Allison 1000 Troubles?? - Chevy Truck Forum | GMC Truck Forum - GmFullsize.com
i would by the truck if the deal is good
the NSBU is easy to replace and fairly cheep
more info: Question Allison 1000 Troubles?? - Chevy Truck Forum | GMC Truck Forum - GmFullsize.com
i would by the truck if the deal is good
#3
tranny help.
I have a 03 LB7. With 101k miles. The truck is 2 wheel drive. It often won't come out of gear. The light indicator. Or linkage. Flashes and the message center reads. SHIFT RANGE INHIBITED?. Yesterday the truck took about 1/4 tp shift out of first. At a steady 2,200 rpm. Runs fine after that. Untill i shut it off and start it again. Where is this sensor located
Thread
Thread Starter
Forum
Replies
Last Post
Max713
5.9 Liter CR Dodge Cummins 03-07
1
04-17-2015 01:18 AM
W350-4x4
1st Generation Dodge Cummins 89-93
4
11-12-2014 09:35 AM