6.5 turbo waste gate sticks open
#1
6.5 turbo waste gate sticks open
My waste gate has been getting stuck open . so I looked into it and I see guys building these spring loaded turbomaster things . they talk about 2 or 3 pounds of boost and then cranking it up to 11 pounds . now is this tention on the spring or is that boost psi ?? Factory turbo on mine produses at least 15 psi because it burys my gague there. I have a chip , cold air , 4 inch straight pipe , 3 inch crossover pipe egt gague and boost gague . Not that it really makes a difference . do these turbo master set ups work good ? Or am I gonna blow my bottom end out ?
Last edited by timmyd; 05-26-2015 at 11:11 PM.
#3
The turbomaster design (personally You'd be better off to make one than buy the factory one) works and is a must if you're playing with your fuel but it takes a little playing around to dial it in just right. But you wouldn't be on here if you weren't willing to tinker. If you turn it up too high it has a safety mechanism built into your boost pressure sensor (the one that your computer reads and I'm not sure that's the right name) that will put you into a limp mode so you can't do any damage. I've done it quite a few times on my 97 you have to shut it off and restart to clear it and go back to normal operation. Overall fairly safe. Mine shuts me down if I hold 15 psi very long at all. And if anyone knows how to bypass it I'd love to know how
Thread
Thread Starter
Forum
Replies
Last Post
klein444
Chevy/GMC 6.2L and 6.5L
3
02-27-2015 01:53 PM